iBootBar
– Precision Version
Page 9
iBootBar_Precision_20160428e.doc
Firmware ver 1.41.32
Command Line Interface
The Command Line Interface follows a
set/get
syntax similar to SNMP.
All configuration is performed from the CLI. It can be accessed via Telnet Client, Serial Port and Dial-up Modem,
using a Terminal client. Below is a listing of all interface commands and syntax.
User Privileges
Each user can be assigned one or more outlets and groups of outlets to manage. Up to 8 users can be defined
Command Set
Device Commands
Description
get device name
Each iBootBar can have a name assigned. 20 characters
Max, no spaces.
set device name <name>
get current
Returns the current draw for each Main in Amperes
set password <oldpass> <newpass> <confirm>
Sets the password for the current user
get cycle
The cycle time is the length of the reboot or power on. In
seconds 0 - 99
set cycle <n>
get console
Display current console configuration
set console timeout <30-3600/disable>
Console can be set to automatically logout with no activity
for 30 seconds to 1 hr in seconds, or disabled.
set console baudrate <baud>
2400, 4800, 9600, 19200, 38400, 57600, 115200
get autologin
Enabled will allow admin rights without use of login
request. Connection will send iBootBar > prompt and not
User Name: request
set autologin <enable/disable>
logout
Ends the session
get modem
Returns all modem parameters
set modem <countrycode>
Set the country code. See Appendix for a list of country
codes and approvals.
set factory defaults
Reset all parameters, including IP address and passwords to
factory defaults. Can only be executed from the serial port.
Confirmation required.
reboot
Reboots the iBootBar itself. Use after firmware upload,
changing IP or SNMP Manager settings. The status of the
outlets will NOT be effected
