iBootBar
– Precision Version
Page 10
iBootBar_Precision_20160428e.doc
Firmware ver 1.41.32
Outlet Commands
Description
get outlets
Returns the name and status of outlets with user rights
get outlet <n>
Returns the name and status of outlet n (with user rights)
set outlet <n> <on/off/cycle>
Commands outlet n to power on/off or cycle (reboot or
power pulse)
set outlets <nnnnnnnn>
Controls outlets to on or off using binary place value.
(n = 0 for off and n = 1 for on)
see Multi Outlet Control
set outlet <n> name <name>
Each outlet can be named for easy identification. 20
characters, no spaces.
get outlet <n> initial.state
Set/Get the initial state of each outlet when the iBootBar is
first powered up.
see Frequent Outlet Control
set outlet <n> initial.state <last/on/off>
Set/Get the initial state of each outlet when the iBootBar is
first powered up.
Returns the current AutoPing configuration for outlet <n>
get outlet <n> autoping
set outlet <n> autoping ipaddress <dotted decimal>
Set the IP address to be pinged for AutoPing
set outlet <n> autoping action <action>
Set the action to be performed when AutoPing is triggered.
none / on-latch / on-follow / off-latch / off-follow / cycle /
cycle-once
set outlet <n> autoping frequency <0-999>
Set the delay between ping attempts
set outlet <n> autoping count <0-99>
Set the number of failures to respond to ping before the
AutoPing feature is triggered
Network Commands
Description
get network
Display current ipmode, ipaddress, subnet, gateway
parameters
set ipmode <arp-ping/static/dhcp>
Set the mode of setting the IP address of the iBootBar.
set ipaddress <dotted decimal>
Set the current IP address. ipmode must be set to static to
use this command.
set subnet <dotted decimal>
Set the Subnet Mask
set gateway <dotted decimal>
Set the Gateway.
get telnet
Display current telnet enable, telnet port parameters
set telnet enable <yes/no>
Enable or Disable Telnet Server
set telnet port <1-65535>
Change the Telnet Server IP port. (default 23)
get protocol
Display the current direct messaging protocol
set protocol enable <ipal/rps/none>
Select direct messaging protocol, or none
set protocol port <1-65535>
set the port for the messaging protocol (default 9100)
get upload enable
Enable or Disable firmware uploading capability.
set upload enable <yes/no>
get time
Returns the current time
set time server <dotted decimal>
Set the time manually or use a time server. If a timeserver
is used, provide the time zone offset.
set time usents <yes\no>
get telnet
Display current telnet enable, telnet port parameters
set telnet enable <yes/no>
Enable or Disable Telnet Server
set telnet port <1-65535>
Change the Telnet Server IP port.
get snmp
Display current SNMP parameters
set snmp writecommunity <name>
32 characters max
set snmp readcommunity <name>
32 characters max
set snmp <n> ipaddress <dotted decimal>
Set up to <n>=1-4 SNMP manager addresses
set snmp <n> enable <yes/no>
Enable or Disable SNMP for manager <n>
get email
Setup email delivery of status and alarm changes. Set the
server address, return address, username and password
needed to authorize email delivery.
set email server <dotted decimal>
set email address <return address>
set email username <user name 128 char max>
- Reboot is required for these settings to take effect. (
reboot
command, reset button or power cycle unit.)
