iBoot-30A
Page 13
iBoot-30a_v101118e
Command Line Interface
The iB-30 Command Line Interface (CLI) provides a text based method for communicating with the
iBoot. The syntax of the CLI uses a basic Set (change a variable) and Get (retrieve a variable). The
CLI is accessed through the Telnet protocol and requires a Telnet client program.
To access the CLI
Open the Telnet client and connect to the IP address set for the iBoot.
Once the conection is made the User: login prompt is presented.
Enter user or admin and press Enter. The prompt will change to Password:.
Enter the admin or user password and press Enter. The prompt will change to iBoot>. This indicates
successful login. Enter commands as needed. When done, enter the logout command.
iB-30 CLI Syntax
Command Description
Factory
Default
CONTROL COMMANDS
These commands are used to monitor and control the outlet.
set outlet <on | off | cycle>
This command controls the outlet.
get outlet
This command returns the current status of the outlet.
DEVICE COMMANDS
These commands are available to the administrator only
get location
This command returns the iB-30’s location ID.
New Boot
set location <20 char. max>
This command is used to set the iB-30’s location ID.
set upgrade enable <yes | no>
Enables or disables the ability to upload new firmware to
the iB-30.
get upgrade enable
This command displays the upload enable status.
logout
Terminates the session
reboot
This command reboots the iB-30.
NETWORK COMMANDS
All set commands require a reboot before they take effect.
These commands are only available to the administrator.
get network
This command will return all the network settings as
shown below:
Mode:
static
IP
Address:
192.168.1.254
Subnet
Mask:
255.255.255.0
Gateway:
192.168.1.1
HTTP
Port:
80
Telnet
Port:
23
