Datamax E Class, Operator'S Manual

Page: 60 / 72

54 Appendix C – Ethernet Setup
TCP/IP Configuration Page
Static IP Settings
IP Address
Subnet Mask
Default Gateway
These are the static address the printer will use when “IP Discovery” is set to disabled or
a valid IP could not be retrieved from a DHCP server.
DHCP Settings
Enable IP Discovery
(DHCP, BOOTP, ect.)
Controls IP Address discovery, where:
Checked: Broadcasts over the network to receive addresses from the responsible
server at startup. Manual modifications to IP Address, Subnet Mask, or Gateway are
not allowed; and, if no server is found, the specified static value will be used.
Unchecked: Uses the stored static IP, Subnet Mask, and / or Gateway Address.
Network Services
Enable SNMP Service Allows management protocols, where:
Sends messages to SNMP-compliant devices.
Sends no messages.
Enable Telnet Service Allows Telnet protocol to transfer data, where:
Telnets to remote computers or server systems.
Disables Telnet.
Enable FTP Service Allows FTP protocol to transfer data, where:
Enables FTP
Disables FTP
Wireless Settings
Enable Wireless Enables or disables the Wireless communication (if equipped) of the network card.
Advanced Settings
Port Number Selects the Port to use for all network communications; Default is 9100
Max Transmission Units Sets the Maximum Transmission Unit packet size, where:
Packet size, in bytes. (512-65515); Default is 1500
Gratuitous ARP (Minutes)
(0=disable) Sets time interval for ARP transmission packets, where:
(0-2048 minutes); Default is 0
Duplex Capability Allows the User to specify the line duplex and speed of the wired Ethernet connection.
Auto-Negotiate (default) 10 BaseT Full Duplex
100 BaseT Full Duplex 10 BaseT Half Duplex
100 BaseT Half Duplex
Advertise Capability Selects the method in which the Duplex Capability setting is advertised, where:
Automatic (advertises the selected Duplex Capability setting)
All Capabilities (advertises all capabilities)
SNMP Trap Destination
Address
Is the address in standard octet format where SNMP traps will be sent when SNMP
service is installed on your receiver. When zeroed, no traps are sent.
NetBIOS (WINS)
Settings
NetBIOS Name Is the name used to reference the printer instead of the IP address. A WINS or DNS
server is required for this capability.
Primary WINS Server The IP address of the primary WINS Server.
Secondary WINS Server The IP address of a secondary WINS Server.
Primary DNS Server The IP address of the primary DNS Server.
Secondary DNS Server The IP address the secondary DNS Server.