Datamax E Class, Operator'S Manual

Page: 35 / 72

Chapter 4 – Maintenance and Adjustments 29
4
4
4
.
.
.
5
5
5
D
D
D
o
o
o
w
w
w
n
n
n
l
l
l
o
o
o
a
a
a
d
d
d
i
i
i
n
n
n
g
g
g
F
F
F
i
i
i
r
r
r
m
m
m
w
w
w
a
a
a
r
r
r
e
e
e
a
a
a
n
n
n
d
d
d
F
F
F
o
o
o
n
n
n
t
t
t
s
s
s
The operating programs and fonts for the printer are stored in Flash memory on the Main PCB. When program
updates and/or new features are added, they can be downloaded to the printer as follows:
1. Identify the new version for your model of printer from the Datamax-O’Neil FTP site at ftp.datamax-
oneil.com and download it onto your computer’s hard drive or a floppy disk.
2. Ensure that the printer is connected to the host and that the power is ‘On.’ Using the DOS copy command
enter:
copy filename.zg lpt1/b

Other programs (e.g., hyper-terminal and certain Windows Driver programs) may also be used to
download this file.
3. The PAUSED Light will flash during the download.
4. Following a successful download , the PAUSED Light will illuminate then the printer will perform a ‘cold
reset.’ The previous printer setup will not be affected unless substantial firmware data structure changes
have occurred. Print a Database Configuration Label to verify your new firmware version.
Following an unsuccessful download , the FAULT Light will illuminate then the printer will perform a
‘warm reset’ (both the POWER and PAUSED Light will be on during power-up initialization). The original
firmware will remain operational. If the printer fails to reset, toggle the power ‘Off’ and ‘On.’
Try re-sending the file to the printer. If the failure continues, check the following possible causes:

An invalid or corrupted file is being downloaded - Ensure the file being downloaded is correct and
applicable for your printer model.

Possible communications error - Check the cable connection between the host and printer and
ensure that a quality, shielded cable is used.

Possible Flash memory problem - Call for service.
If the printer fails to boot-up after an unsuccessful download, turn ‘Off’ the power. Simultaneously press and
hold the
F1 + F3
buttons while powering ‘On’ the printer. Now, try downloading the file to the printer again.