Datamax Apex 4, User Manual

Page: 7 / 30

3
1.2 Installing and Charging the Battery Cartridge
Note: One battery cartridge is included with the printer. Similar to a cordless phone battery, the
printer’s battery must be charged before using it. For optimal performance, we
recommend charging the battery twice before initial use. Charge the battery for 3 hours;
disconnect power adapter, reconnect, and charge again. After initial charge, charge
battery for 180 minutes whenever the low battery indicator comes on or as directed by
your IT team.
Datamax-O’Neil batteries must be cycled several times to achieve maximum capacity. To
cycle a battery, fully charge it and then allow full discharge through normal use in the
printer.
1.2.1
Installing the Battery
Note: Refer to Figure 2 below to install the battery pack in the printer.
Unlock the battery door by sliding the battery door locking tab up.
Open the battery door to an angle of about 90 degrees. Do not force open.
Insert the battery as shown (non-contact end first and let contact end drop into place).
Close and lock the battery door by sliding the locking tab down.
FIGURE 2: INSTALLING THE BATTERY CARTRIDGE
Note: If paper door does not open easily, tap the printer against the palm of your hand near the
paper door hinge.
Note: Ensure that battery side with 2 contact terminals is facing down to make contact with the
spring probes inside the battery compartment