DATAMARS
R-IN 1300 MC User Manual – Rev
6.0
8 (50)
*co[_]
Continuous mode:
*co1 continuous mode on (default)
*co0 continuous mode off
*in[_]
Number of inventories (for non continuous mode only)
*in[1..9] (default 1 [inventory], example *in5)
*id[_]
Delay (ms) between two inventories (for non continuous mode
only)
*id[0..1000] (default 0ms, example *id530)
*rh[_]
Remove headers:
*rh0 does not remove the headers
*rh1 removes the headers (default)
*ec[_]
Echo:
*ec0 echo disabled (default)
*ec1 echo enabled
“echo” makes it possible to view the characters sent to the
reader.
*sa[_]
Stand alone mode:
*sa0 stand alone mode disabled (default)
*sa1 stand alone mode enabled (detect)
When stand alone mode is enabled, the device will start reading
as soon as it is turned on.
*bu[_]
Buzzer Box (beeper).
*bu0: buzzer disabled
*bu1: buzzer activated on tags-detection
*bu2: buzzer activated on antenna-transmission
*it[_]
Input trigger: The reader will start working only when the external
inputs will allow it, as shown in the following details.
Recommended for single-read operational mode.
*it0 input trigger disabled (default)
*it1 input trigger 1 enabled
*it2 input trigger 2 enabled
*it3 input trigger 1 enabled (reversed edge-logic)
*it4 input trigger 2 enabled (reversed edge-logic)
Details for *it1:
IN1
Use:
•
When IN1 is high level, it’s possible to read the transponder.
•
t
1
min 50 ms.
•
See Appendix C to know where IN±1 pins are located in the I/O connector.
•
See Appendix B for electrical characteristics of the input.
Details for *it2:
IN2
Use:
•
The rising edge of IN1 starts reading.
•
The rising edge of IN2 stops reading.
IN1