Charging the Batteries
4
QuickScan™ I QD24XX/QBT24XX/QM24XX
Charging the Batteries
The battery can be charged by connecting the reader directly to a host through the micro-USB
connector available in the bottom of the handle, as shown.
Micro-USB
Connector
Alternatively, simply insert the QuickScan into the base. When the scanner is fully seated in the
cradle, it will sound a “chirp” to indicate that the cradle has detected the scanner connection.
The LEDs on the base will indicate the status of the battery.
Before using the Battery, read “Battery Safety” in the following section. Datalogic recommends
annual replacement of rechargeable battery packs to ensure maximum performance.
Battery Safety
To reinstall, charge and/or perform any other action on the battery, follow the instructions in
this manual.
Before installing the Battery, read “Battery Safety” on this and the following pages. Data-
logic recommends annual replacement of rechargeable battery packs to ensure maximum
performance.
WARNING
Do not discharge the battery using any device except for the scanner. When the battery is
used in devices other than the designated product, it may damage the battery or reduce its
life expectancy. If the device causes an abnormal current to flow, it may cause the battery
to become hot, explode or ignite and cause serious injury.
Lithium-ion battery packs may get hot, explode or ignite and cause serious injury if
exposed to abusive conditions. Be sure to follow the safety warnings listed below:
•
Do not place the battery pack in fire or heat.
•
Do not connect the positive terminal and negative terminal of the battery pack to each
other with any metal object (such as wire).
•
Do not carry or store the battery pack together with metal objects.
•
Do not pierce the battery pack with nails, strike it with a hammer, step on it or otherwise
subject it to strong impacts or shocks.
•
Do not solder directly onto the battery pack.
•
Do not expose the battery pack to liquids, or allow the battery to get wet.
•
Do not apply voltages to the battery pack contacts.
WARNING
In the event the battery pack leaks and the fluid gets into your eye, do not rub the eye.
Rinse well with water and immediately seek medical care. If left untreated, the battery fluid
could cause damage to the eye.
Summary of Contents for QuickScan QM24 series
