Enter/Exit Programming Mode
50
PowerScan™ PD953X/PBT950X/PM950X
Global Prefix/Suffix (Header/Terminator)
This option sets up to 20 characters each from the set of ASCII characters or
any hex value from 00 to FF. The characters may be added as a prefix (in a
position before the bar code data, also called a header) and/or as a suffix (in
a position following the bar code data, also called a terminator). See
for more detailed instructions on setting this feature.
To configure this feature, scan the ENTER/EXIT PROGRAMMING MODE bar
code above to place the unit in Programming Mode, then the “Set Global
Prefix” or “Set Global Suffix,” bar code followed by the digits (in hex) from
the Alphanumeric characters in
representing your
desired character(s). If less than the expected string of 20 characters are
selected, scan the ENTER/EXIT bar code to terminate the string. Exit pro-
gramming mode by scanning the ENTER/EXIT bar code again.
Set Global Prefix
Set Global Suffix
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
No Global Prefix
Global Suffix = 0x0D (CR)
Summary of Contents for PowerScan 950X Series
