Datalogic Magellan 800i, Reference Manual

Page: 54 / 184

Interface Related Features
46
Magellan
TM
800i
USB Keyboard — cont.
Intercharacter Delay
USB COM Interface Set-up
To set the reader to use the USB Com interface, follow these instructions:
1. Download and install the USB Com driver available from the www.datalogic.com web-
site.
2. Program the reader for the USB Com interface using the bar code located on
page 26
.
3. Plug and play.
START / END
PROGRAMMING BAR CODES
If the transmission speed is too high, the system may not be able to receive all characters. You may need to adjust the delay to make
the system work properly. Selectable from 00 to 99.
USB Keyboard: 00 = 1 ms USB Host poll rate. Non-zero values less than 25 are 10 ms increments in USB Host poll rate values
greater than 25 result in a USB Host poll rate of 255 ms.
To configure this feature, scan the “START/END” bar code above to place the unit in Programming Mode, then the “Set Intercharac-
ter Delay,” followed by the two digits (zero padded) from the Alphanumeric table in
Appendix C, Alphanumeric Pad
representing
your desired length. Exit programming mode by again scanning the “START/END” bar code above/
DEFAULT SETTING FOR THIS FEATURE:
01
Set Intercharacter Delay
0287(CR)