2
Magellan
TM
3300HSi
Installation
Connect the scanner to the host (terminal) using the interface (I/
F) cable as shown in
Figure 2
. A cable from an older existing instal-
lation can be re-used if it uses Power Off the Terminal (POT),
unless it is a USB POT cable. If external power is used/needed,
plug the AC Adapter into the AC wall outlet, then connect it to
the I/F cable as shown in ‘b’ and ‘c’ of the illustration.
Scan some known-good bar code samples to verify correct opera-
tion. The scanner should beep and/or flash its good read LED
1
and send the bar code data to the host or terminal. If not, use the
Troubleshooting sec-
tion of this guide to
identify any prob-
lems.
Remove the Top
Cover and use the lift
handles provided (see
Figure 1
) whenever
lowering or lifting
the scanner from the
counter.
Scanner installation
is complete.
Figure 2.
Connections
1. Be aware that beeper and LED behavior may have previously been configured
as “disabled” by another user.
US
B
U
S
B
R
S
-2
32
IB
M
or...
or...
Power Off
the Terminal
(POT)
Terminal (PC)
To Terminal (PC)
To Terminal (PC)
Keyboard Wedge, RS-232 and USB Cables
Powered by AC Adapter
Other Non-POT Cables
Powered by AC Adapter
via short adapter cable
RS
-2
3
2
a
b
c
Keyboard
Wedge
