Installing to DOS Terminal
Read all information in the section "Safety Precautions" at the beginning of this
manual.
1) Rhino™ will recognize the card if the correct drivers are loaded. Therefore,
before inserting the card into the terminal make sure that:
-
in NEWCFG.SYS the driver for the PCMCIA serial ports is loaded:
A:\PCMCIA\PCMSCD.EXE
- the scan engine driver is correctly configured (COM 3, interrupt 5) and
loaded after PCMSCD.EXE:
A:\DRIVERS\REDIR.SYS -c3 -i5 -b3
The following is an example of the NEWCFG.SYS:
;Load PCMCIA drivers
DEVICE=A:\PCMCIA\CNFIGNAM.EXE /DEFAULT
DEVICE=A:\PCMCIA\PCMSSC40.EXE
DEVICE=A:\PCMCIA\PCMCSFUL.EXE
DEVICE=A:\PCMCIA\PCMRMAN.SYS
DEVICEHIGH=A:\PCMCIA\PCMSCD.EXE
; Scan Engine Device Driver
; (Emulate SE1200 on Com3 @ 9600 N-8-1 Irq5)
DEVICEHIGH=A:\DRIVERS\REDIR.SYS -c3 -i5 -b3
2) Insert the DLCC correctly in the PCMCIA slot. Refer to the terminal user's
manual.
Figure 2 - DOS Terminal Card Installation
x
Summary of Contents for DL Cordless Card DLCC
Page 14: ...xiv...
