DKG-325 User Manual Firmware V-56
- 26 -
The program mode is used to program timers, operational limits and the configuration of the unit.
To
enter the program mode
, hold pressed the
MENU
button for 10 seconds.
When the program mode is entered, if the MENU button is pressed, the display will indicate the
program parameter number. When the button is released, the display will show the parameter value.
The program mode will not affect the operation of the unit. Thus programs may be modified anytime,
even while the genset is running.
Navigation between program parameters is performed via the
MENU
button. Holding the button
pressed will cause the program parameter number to increase faster.
Parameter value may be increased and decreased with RUN (
▼)
and AUTO (
▲)
buttons. If these
keys are held pressed, the program value will be increased/decreased faster.
When a program parameter is modified, it is automatically saved in memory.
If
MENU
button is pressed, next parameter will be displayed.
Program parameters are kept in a non-volatile memory and are not affected from power failures.
To
exit the program mode
press STOP key. If no button is pressed during 1 minute the program
mode will be cancelled automatically.
Program parameters are organized in 2 groups as low and high levels. Entering the program mode by
pressing the
MENU
button will allow access to only low level parameters.
In order to access all parameters please hold
STOP
and
MENU
buttons pressed together for 10
seconds.
10. PROGRAMMING
