Data Translation DT330 Series, User Manual

Page: 64 / 110

Supported Device Driver Capabilities
63
Data Flow and Operation Options
Table 11: DT330 Series Data Flow and Operation Options
DT330 Series A/D D/A DIN DOUT C/T QUAD
Single-Value Operation Support
SupportsSingleValue Yes Yes Yes
Simultaneous Single-Value Output
Operations
SupportsSetSingleValues
Continuous Operation Support
SupportsContinuous Yes
a
a. Only Port D when configured for 8-bit resolution can operate in continuous digital input mode
and only if you enabled interrupt usage for this port in the driver configuration dialog box. The
software generates an event when a digital input line in this port changes state.
Continuous Operation until Trigger
SupportsContinuousPreTrigger
Continuous Operation before & after Trigger
SupportsContinuousPrePostTrigger
Waveform Operations Using FIFO Only
SupportsWaveformModeOnly
Simultaneous Start List Support
SupportsSimultaneousStart
Supports Programmable Synchronization
Modes
SupportsSynchronization
Synchronization Modes
SynchronizationMode
Interrupt Support
SupportsInterruptOnChange Yes
b
b. When using 8-bit resolution only, the DT330 Series boards can generate a PCI-bus interrupt
when any of the eight digital input lines corresponding to digital Port D (DIN element 3)
changes state. This feature is useful when you want to monitor critical signals or when you want
to signal the host computer to transfer data to or from the board. You enable the interrupts on a
line-by-line basis during DT330 driver configuration; refer to
page 27 for more information on
configuring the driver. If you are using the DataAcq SDK, refer to page 59 for more information
on determining which digital input lines changed state.
Output FIFO Size
FifoSize
Auto-Calibrate Support
SupportsAutoCalibrate
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com