Data Translation DT3152-LS, Getting Started Manual

Page: 37 / 84

Connecting Signals
27
4
4
4
4
4
4
4
4
4
Connecting Signals to Connector J1 on
the Board
To connect signals to connector J1 on the DT3152-LS board, perform
the following steps:
1. After making sure power to the computer is off, push the 15-pin
connector of the EP306 cable into the J1 socket at the rear of the
DT3152-LS board, as shown in
Figure 4 , and tighten the screws
on the connector.
Figure 4: Connecting the EP306 Cable Assembly to Connector J1
2. If you are using AC-coupled video sources, connect a video
source to EP306 connectors 0 (VID0), 1 (VID1), 2 (VID2), and/or
3 (VID3).
If you are using a DC-coupled video source, connect the video
source to EP306 connector 3 (VID3).
J1
J2
0 VID0
1 VID1
VID2 2
VID3 3
FRAME_SYNC 4
EXT_TRIGGER 5
LINE_SYNC 6
EXT_CLOCK 7
EP306
D_IN1 8
D_IN0 9
D_OUT3 10
D_OUT2 11
D_OUT12
13 D_OUT0