18
12044128 Rev. 00
D ATA M O D U L AG | w w w .data-m odul.com
Legacy Console Redirection Settings
Param eter
V alue
Com m ent
Redirection CO M Port
CO M 0
CO M 1
CO M 2
CO M 3
Select a CO M Port to use for Legacy O S and Legacy
O PRO M Console Redirection.
Resolution
80x24
80x25
O n Legacy O S, the N um ber of Row s and Colum ns
supported by redirection.
Redirection After PO ST
Enabled
D isabled
Enabled: Console Redirection is available for Legacy
O S.
D isabled: Legacy console redirection is disabled
before booting to Legacy O S.
Serial Port for Out-of-Band Management/Windows Emergency Management Services (EMS)
Param eter
V alue
Com m ent
O ut-of-B and M gm t Port
CO M 0
CO M 1
CO M 2
CO M 3
Select a CO M Port to use for M icrosoft W indow s Em ergency
M anagem ent Services (EM S).
EM S allow s for rem ote m anagem ent of a W indow s Server O S
through a serial port.
Term inal Type
VT100
VT100+
V T-U TF8
AN SI
VT-U TF8 is the preferred term inal type for out-of-band
m anagem ent. The next best choice is VT100+ and then VT100.
See above, in Console Redirection Settings page, for m ore H elp
w ith Term inal Type/Em ulation.
B its per seconds
9600
19200
57600
115200
Selects serial port transm ission speed. The speed m ust be
m atched on the other side. Long or noisy lines m ay require
low er speeds.
Flow Control
N one
H ardw are RTS/CTS
Softw are Xon/Xoff
Flow control can prevent data loss from buffer overflow . W hen
sending data, if the receiving buffers are full, a 'stop' signal
can be sent to stop the data flow . O nce the buffers are em pty,
a 'start' signal can be sent to re-start the flow . H ardw are flow
control uses tw o w ires to send start/stop signals.
Connectivity Configuration
Param eter
V alue
Com m ent
CN Vi M odule
D isable
Enable
Enable/D isable integrated CN Vi m odule.
Advanced settings
D isable
Enable
Configure ACPI objects for w ireless devices.
