Quick start guide
Handling and settings
13
EN
GLIS
H
Synchronizing the cut position
when using different paper ways
If you use different paper ways it is possible that minor divergences of the adjusted
cut position occur when switching between the paper ways. You can eliminate
these divergences from the adjusted cut position by means of the parameter
Sync.Lab
in the test menu of the printer. In this case you have to use paper with a
black label on the back. This label is scanned after switching on the printer, when
changing paper and loading paper.
See section
Technical data
and
Paper specifications
for details about the position,
the dimensions and the density of the label.
To activate the parameter
Sync.Lab
, which is switched off by default, proceed as
follows:
First set to printer to test mode by pressing the
Online
key while switching on the
printer.
The display shows
Test mode
for about 1 second and then
ASCII 80 ASCII 136
.
Change to the parameter group
Paphand
by pressing the
Next
key (4) three times.
Press the
Paphand
key (2).
Press the
Next
key (4) several times until the
Sync.Lab
parameter appears in the
display.
Press the
Sync.Lab
key (3).
ASCII80 ASCII136
Back
Next
Online
Setup
2
1
3
4
Paphand CX-bid
Back
Next
Online
Setup
2
1
3
4
Physlm
Sync.Lab
Back
Next
Online
Setup
2
1
3
4
Cutter-en.book Seite 13 Donnerstag, 3. Mai 2007 9:42 09
Summary of Contents for Tally T2150S
