Dascom DC-2300, User Manual

Page: 17 / 70

DC-2300 User Manual v1.0
3
1.2 Operating the Printer Safely
The following precautions must be observed to assure safe operation of your printer. Do not do
anything that is not described in this manual. Doing so could cause an unexpected failure. The
manufacturer is not responsible for any problems caused by incorrect operation of the printer.
Installation
location
Do not install the printer in a damp or dusty location.
Do not install the printer near flammable or explosive materials or a heater,
stove or any other device that produces heat. Do not place the printer near
volatile combustible materials such as combustible materials.
Place the printer away from walls to maintain air flow. Also, maintain at least
30 cm (12 inches) of open space above the printer.
Blocking vents may cause the printer to overheat and fail prematurely.
Do not install printer on an unstable table, on a slant, or any place where
there is excessive vibration.
Do not install the printer in a location susceptible to rapid fluctuations in
temperature.
Do not install the printer in a location exposed to direct sunlight.
Power supply Use a dedicated power cable and do not use an extension cord with multiple
outlets.
Be sure to remove any dust from the plug and electrical outlet.
Humidity produces a micro-current on the surface causing overheating.
Do not damage or modify the Power Cable. Also, do not place heavy objects,
pull, or bend power cord excessively.
Do not plug in or unplug the Power Cable if your hands are wet.
Ensure a ground wire is connected.
When connecting the ground wire, note the following cautions.
Recommended connections for ground wires
Electrical outlet ground terminal
Ground terminals installed as type A, B, or C
A copper rod 65 cm (25.6 inches) or longer buried in the ground.
Not permitted for ground wires
Gas piping (risk of fire or explosion)
Water pipes or taps (water pipes that include plastic piping cannot act as a
ground However, if a water pipe is configured to act as a ground, then
connection of a ground wire is permitted.)
Telephone line ground wires or lightning conductors (danger of high current
flow in the event of a lightning strike.)
Be sure to turn off power and unplug the plug from electrical outlet before
moving the printer.
Pull on the plug or cable when unplugging it from an electrical outlet.
Do not use an under-rated extension cord.
Handling
Do not use flammable sprays near the printer.
Do not touch anything inside the printer unless specified in this manual.
Do not place heavy items on the printer and do not lean on the printer.
While the printer is operating, do not turn off the power, unplug the power
cable, or look inside (open) the printer.
WARNING
The lower part of the Top Access Cover, the printer internal heat roller section, and
the thermal head section become very hot. Ensure you do not touch these three
locations.