DAS AUDIO INTEGRAL-MA, User Manual

Page: 30 / 48

30 Manual INTEGRAL-MA
INTEGRAL
Front display navegation and settings
AMP BRIDGE
Channels AMP-1 and AMP-2 can be bridged to double the power or
obtain 100V / 70 lines.
Channels AMP-3 and AMP-4 can be bridged to double the power or
obtain 100V / 70V lines.
Channels can only be bridged when the nominal load or impedance
is greater or equal to 8ohm or when systems with transformers have
been installed (high impedance lines).
Select the desired channel with the UP /
DOWN keys and press ENTER. Using the UP
/ DOWN keys, activate (ON) or deactivate
(OFF) Bridge mode.
Note that it is not necessary to set the four channels in Bridge mode
at once. You can choose a hybrid configuration where AMP-1 and
AMP-2 work with an independent signal and in low impedance, and
where channels AMP-3 and AMP-4 are in bridge mode with one sig-
nal to amplify a line of systems with transformer (high impedance).
PRIORITY
The 8 processor outputs included in the INTEGRAL-MAxxxx devic-
es (AMP-1, 2, 3, 4 y AUX-1, 2, 3, 4) can have up to TWO priority levels.
The priority channels available are: IN-A, IN-B, IN-E, IN-F; that is, two
analog and two digital channels, with a maximum of 2 per output
channel.
From the front panel display, it is only possible to choose ONE prior-
ity level per output channel. ALMA can be used to access advanced
settings like doble priority level per output channel, threshold set-
tings, release, attack time, gain reduction, etc.
It is not necessary to route the priority input
channels for each output from the SRC Se-
lection menu. That is, if for output channel
AMP-1, you have selected as input sources
the sum IN C+D and want input A (IN-A) to
have priority, it is not necessary to access
the SRC Selection menu to select IN-A as AMP-1´s input channel.
Just select from the Priority menu IN-E as the priority input assigned
to AMP-1.