DAS AUDIO INTEGRAL-MA, User Manual

Page: 19 / 48

19 Manual INTEGRAL-MA
INTEGRAL
Dante digital channel configuration
Digital Audio Channel Configuration with Dante Controller
1 Start Dante Controller
2 Automatically, the program will detect all the units present on
the network and will show them in the main screen; if this is the
first time the units are connected to the network, their names
might show in Dante as follows:
Note: If a unit fails to appear because it has not been detected by
Dante Controller, the reasons could be:
• The unit has no power or has not been switched on.
• The CAT5e cable, or superior, is defective or incorrectly connected.
• The unit is in a different subnet.
• The unit is not able to synchronize with the other devices on the
network.
However, if one of the two last reasons applies, the unit should at
least appear under the tabs “Device Info” or “Clock Status.” A quick
solution to the problem may be to turn the unit off and on and re-es-
tablish the connection with the Ethernet switch.