MRS v1.7 10
REPLACING OF THE INK CARTRIDGE:
1- For the MRS x2xx: tear off the rewinded paper .
2- Unscrew the two unremovable screws (1 and 2). The panel ( 3 ), in front of
the revolving door, can then be removed giving access to the ink cartridge
( 4 ).
3- On the left part of the ink cartridge( 4 ) is a marked carving " PUSH "; press
on this carving, the ink cartridge lifts up itself then take it off.
4- Insert a new cartridge by watching if the paper goes between the ink band
and the body of the cartridge. Position the cartridge so that the button of
tension of the ribbon is in front of its spur of training. Press on the two
extremities of the cartridge which go in the right position and a light click
sound indicates that it is correctly set.
5- Pull about 20 cm of paper towards the outside thanks to the paper feed
button (if the printer is not under power, it is possible to pull the paper by
hand under the condition of not pulling it too fast).
6- Put back the panel ( 3 ) having made the paper cross through the plexiglas
window ( 5 ). Plug the low part of the panel at the top of the door hinge (6)
then stick it to the revolving door.
7- For the MRS x1xx: Go directly to the step 11.
8- For the MRS x2xx: Put the two unremovable screws (1 and 2) in the
revolving door without screwing them
9- Open then the revolving door ( 7 ) of the printer which gives access to the
paper rewinder ( 10 ). Remove the freezing fork of the paper rewinder by
pulling it to the left. Then remove all the rewinded paper from the paper
rewinder.
10- Place the extremity of the paper against the central pit of the rewinder ( 10 )
and block it with the blocking fork.
11- Close the revolving door ( 7 ) and completely screw the two unremovable
screws (1 and 2)
age
Pa
P
ge: 8 of 8.
