Copyright © 2008 – 2019 DARE!! Products
Page 11
3.
Installation
3.1
Hardware Configuration
3.1.1
For stand-alone use
1.
Connect the Radi
P
ower
®
sensor to a Windows computer with a USB 1.1 compatible
port. Use the supplied USB cable to connect the Radi
P
ower
®
sensor.
3.1.2
For use in combination with a RadiCentre®
The hardware configuration is carried out in the following 7 steps
2
:
1.
Choose the slot of the Radi
C
entre
®
system in which you want to install the plug-in
card.
2.
Remove the blind panel from this slot by removing the four screws of the panel
(two on top and two at the bottom). See Figure 3.
3.
Gently insert the plug-in card
into the slot of the Radi
C
entre
®
and reinsert the four
screws. See Figure 3.
Figure 3: Example of a (Radi
S
upply
®
LPS1001A) plug-in card installation
*Steps 4 to 7of the hardware configuration are visible on the next page.
2
These are the basic steps in a plug-in card installation, the exact installation of your plug-in card may vary.
