NET-FRM01 Users Manual (Rev 1.3)
-
27-
http://www.daqsystem.com
5.1 Image Frame Function
(1)
“Dev. Open” button
It starts a selected board device.
If it is “0”, it is the normal state. If it is “-1”, the device is not recognized.
(2)
“Dev. Init” button
Press this button to initialize the function of receiving image frame data. It is performed only
once after power is applied to the board.
(3)
Mode Selection
It selects a Video Data Mode of 8bit, 16bit, 24bit, 32bit.
(4)
“Get Res.” button
It shows the image resolution.
(5)
“Start” button
It starts the image transfer. It is a Toggle button, press again stop the image transferring.
(6)
“Once” button
When press this button, it displays a freeze-frame.
(7)
“View” button
Start the image transmission.
(8)
“Data” button
Press this button to read the image frame data of the board to your PC(Hex Value). If image
frame data is not saved on the board, you must wait until the end of data collection.
(9)
“Auto” toggle
When check this box, it displays a video
