(833)-DAPPER-1 / (833)-327-7371
www.dapperlighting.com
32
Back up the vehicle 20 feet so that it is 25 feet away from the vertical surface. Check to see if the cuto! point is
directly in between the two marks you have made.
Mark two more spots 2" below the spots you first marked.
If your headlight cutoff is not in between the two markings, the headlights need to be realigned. To do so, use
the adjustment screws on the rear bracket of each headlamp.
Turning the top adjusting screws in a clockwise direction will raise the beam while counterclockwise turn will
lower it. Turning the side adjuster screws will adjust the lights to the left or right.
Continue the adjustments until the light beams are even. Have the lights on while you are doing this. Make the
proper adjustments so that the cutoff is level and falls in between the spots you have marked.
You may need a special screwdriver for your vehicle model.
STEP 5:
STEP 6:
STEP 7:
HEADLIGHT AIMING
Instructions
