(833)-DAPPER-1 / (833)-327-7371
www.dapperlighting.com
31
Locate the adjusting screws of the
headlights on the back of the
housing assembly.
There are horizontal and vertical
screws which have small spring
behind them.
Typically, one of the screws is on
the top of the housing assembly,
while the other screw is on the
inside edge.
Mark the horizontal centerlines of
the lights on the wall using a
masking tape.
Mark the vertical centerline for
each light as well.
The marking will tell you where
exactly the headlights should be
centered.
STEP 3:
STEP 4:
HEADLIGHT AIMING
Instructions
2”
These vertical lines need
to intersect the slant on
the cutoff in order for
you’re lights to be
centered from left to right.
The vertical lines need to
be perpendicular to the
driveway
This line is level
with the center of
the projectors.
This tape is 2” lower
than the center of the
projectors.
This is where your
headlights shine when
your bumper is as close
to the garage door/wall
as possible.
