DAPAudio ZA-240VTU, Manual

Page: 12 / 19

11
Operation
Installation
Remove all packing materials from the ZA-240VTU. Check that all foam and plastic padding is removed.
Secure the equipment into a 19" rack if preferred. Connect all cables.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 115V specification product on 230V power, or vice versa.
Before powering up the first time, make sure the AC-selector switch is set to the proper voltage.
Damage caused by connecting the amplifier to improper AC voltage is not covered by any warranty.
NOTE: Always turn off and disconnect the amplifier from mains voltage before making audio
connections. Also, as an extra precaution, have the attenuators turned down during power -up.
Connecting Inputs
Use jack input at the front or the XLR input connectors at the rear to supply audio signals to your DAP
Audio PA-Series amplifier. The XLR connectors accept balanced and unbalanced audio connections. (All
DAP audio amplifiers are configured standard with "Pin 2 hot" on XLR inputs. For more Information, see the
section on Connection cables on page 15.
Operating the Tuner
Selecting a station
Use the AM/FM (20) button to select either AM or FM band. Push the (25) or (26) button to tune
stepwise.
Pushing the
(25) or (26) button for more than 1second will let you speed up the searching.
Selecting a preset.
Use the AM/FM (20) button to select either AM or FM band.
Push M1 (21) , M2 (22) , M3 (29) , M4 (32) or M5 (33) to recall preset M1-M5.
Storing a station in Memory
Push the memory (28) button. “Memory” appears in the display and the preset number changes into a
line.
Now push button M1 (21) , M2 (22) , M3 (29) , M4 (32) or M5 (33) to store the preset in the desired memory
location.