DAPAudio Xtreme X-1300, Product Manual

Page: 8 / 15

6
Installation
Remove all packing materials from the Xtreme. Check that all foam and plastic padding is removed.
Screw the equipment into a 19" rack. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.
Install this device on a flat surface, not bending or curved.
Do not supply power before all components of the system are set up and connected properly.
There are 3 different modes: Offline Mode, Online Mode, PC Software Operation
OFF LINE MODE
Switch on the power, the system accesses the OFFLINE mode.
A. Adjust the volume: turn CHA/CHB button to adjust the input level of CHA/CHB.
B. Setup the amplifier ID:
Press CHA button for about 3 seconds, the LCD shows:
SETUP AMPLIFIER ID
DEVICE NO.#1
Then, turn CH A to change the amplifier ID from 1 to 255. Press CH A button again and save the setting.
C. Load program
Press the CH B button for about 3 seconds, the LCD shows:
LOAD PROGRAM P : 11
NO PEQ+XOVER+DELAY
Then, turn CH A to select one program [ 1 -11 ]. Press CH B button again, save the setting and load the
selected program. At the same time, the LCD shows: LOADING…….. Several seconds later, LOADING is
finished and the system returns to the menu
D. SETUP VOLUME PROTECT: Under menu LOAD PROGRAM, press the CH B button again for about 3
seconds and then the LCD shows:
VOLUME MUTE PROTECT
AUTO MUTE : ON
Turn the CH B button to switch on/off AUTO MUTE. Then, press the CHB button again to save the setting.
AUTO MUTE: ON. When the power is on, the volume of CH A/CH B is automatically MUTE.
AUTO MUTE: OFF. When the power is on, the volume of CH A/CH B returns to the setting, when the
power was off the last time.
Note :
1. Program No. 11 is not used in the online mode without PEQ, XOVER and DELAY. The other 10 programs
can be saved and recalled in the online mode.
2. The volume is automatically muted after every LOAD PROGRAM.
3. When the system switches from the online mode to the offline, the system can load the program that is
saved in the online mode. At the same time, the volume is muted automatically.
Amplifier ID
Program Number
Program Name