DAPAudio PM-Six, Manual

Page: 8 / 12

7
Ordercode: D6182
PM-Six
Fig. 03
Function DIP switches
Set DIP switch # 1 to ON/OFF position, to activate/deactivate digital messages.
If you connect multiple devices, and DIP switch # 2 is set to PRIORITY position, you have priority to
speak. If DIP switch # 2 is set to SLAVE position, you need to wait until the BUSY LED indicator stops
blinking.
Microphone RJ45 – LINK
Use this connector to connect two or more devices. Connect the OUTPUT connector on the master
device to the LINK connector on the slave device, etc.
Microphone RJ45 – OUT
Use this connector to connect the PM-Six to another PM’s LINK connector or to the input connector
on the ZPA-6240TU.
RCA Aux – IN
External audio input. Transmits the MIC signal and the mixed voice to the host.
Microphone sensitivity control
Turn the control to set the microphone’s sensitivity.
Installation
Remove all packing materials from the PM-Six. Check if all foam and plastic padding is removed.
Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.