DAPAudio EDGE EBS-2 V2, User Manual

Page: 20 / 36

19
EDGE EBS-2
Product code: D1480B
Switching ON/OFF – Transmitter
The transmitter has a power button.
Press and hold down the power button (24) for 2 seconds to switch the transmitter on/off.
Pairing
You can pair the transmitter with the receiver.
Before pairing, scan for unused frequencies to avoid interference. See 5.3.1.4. Scan on page 22.
To automatically pair the receiver with the transmitter, follow the steps below:
Put the transmitter near the receiver, so that the IR sensor (30) of the transmitter is as close as possible
to the IR sensor (06) of the receiver.
Follow the steps in 5.3.1.5. Synchronization on page 23.
To manually set the transmitter and the receiver to the same channel and frequency, follow the steps
below:
Select a group on the receiver. See 5.3.1.1. Group on page 21.
Select a channel on the receiver. See 5.3.1.2. Channel on page 22.
Select a frequency on the receiver. See 5.3.1.3. Frequency on page 22.
Follow the steps in 5.4. Control Panel – Transmitter on page 27.
5. Operation
Safety Instructions for Operation
Attention
This device must be used only for the purposes it is designed for.
This device is intended for use as a wireless bodypack system. It is suitable only for indoor installation. It is
not suitable for households.
Any other use, not mentioned under intended use, is regarded as non-intended and incorrect use.
Attention
Power supply
Before connecting the device to the power supply, make sure that the current, voltage and frequency
match the input voltage, current and frequency specified on the information label on the device.
Operation
To operate the device, talk or sing into the headset, microphone or play the instrument connected to the
transmitter. The AF signal strength (L) indicator on the LCD display (01) increases or decreases during
talking/singing. If the signal is too loud, “AF” and “P” of the AF signal strength (L) indicator flash red.
After use:
Mute the transmitter to prevent the occurrence of a popping sound. See 5.5.2. Mute on page 28.
Switch off the receiver and the transmitter. See 4.3.5. Switching ON/OFF – Receiver on page 18 and
4.3.8. Switching ON/OFF – Transmitter on page 19.