28
Do not install the heat pump at any place where flammable
gas may leak out.
If the gas leaks out and stays around the heat pump, a fire may
break out.
The appliance is not intended for use by young children or
infirm persons without supervision.
Young children should be supervised to ensure that they do not
play with the appliance.
The monobloc window-shades should be periodic
cleaning in case of being jammed.
This window-shapes is heat dissipation outlet of components, if
being jammed will cause the components shorten their service
life spans because of overheated for a long time.
The temperature of refrigerant circuit will be high, please
keep the interconnection cable away from the copper tube.
10.3 Heating capacity
•
The heating operation is a heat-pump process that heat will be
absorbed from outdoor air and released to indoor water. Once
the outdoor temperature is decreased, heating capacity
decreased correspondingly.
• Other heating equipment is suggested to be used together when
outdoor temperature is too low.
• In some extreme cold upland that buy the monobloc equipped
with electrical heater will obtain better performance.
10.4 Compressor protection feature
A protection feature prevents the heat pump from being
activated for approximately several minutes when it restarts
immediately after operation.
10.5 Cooling and heating operation
The the monobloc in the same system can not run cooling and
heating at the same time.
If the Heat Pump Administrator has set running mode, then the
heat pump can not run on modes other than the presetted.
Standby or No Priority will be displayed in the Control Panel.
10.6 Features of heating operation
Water will not become hot immediately at the beginning of the
heating operation, 3~5 minutes ago (depends on the indoor and
outdoor temperature), until the indoor heat exchanger become
hot, then becomes hot.
During operation, the fan motor in the monobloc unit may stop
running under high temperature.
10.7 Defrost in the heating operation
During heating operation, monobloc unit sometimes will frost. To
increase efficiency, the unit will start defrosting automatically
(about 2~10 minutes), and then water will be drained out from
monobloc unit.
During defrosting, the fan motors in the monobloc will stop running.
•
•
•
•
CAUTION
10 OPERATION AND PERFORMANCE
10.1 Protection Equipment
Cooling Operation
This Protection Equipment will enable the Heat Pump to stop when
the Heat Pump is to be directed running compulsively
.
10.2 About power cut
If power is cut during operation, stop all the operation immediately
in case of power comes again. If the auto-restart function is set
on,then the unit will auto-restart.
•
The air inlet or air outlet of monobloc is blocked.
•
Strong wind is Continuously blowing to the air outlet of the
monobloc unit.
Heating Operation
•
Too much rubbish adhere to the filter in the water system.
•
The air outlet of monobloc is choked.
•
Mishandling in operation:
If mishandling happens because of lighting or mobile wireless,
please shut off the manual power switch, and turn on again,
then push the ON/OFF button.
The protection equipment may be activated in following conditions:
When the protection equipment starts, please shut down the
manual power switch, and restart operation after problem is
solved.
NOTE
1) The fan motor will continue running for 60 seconds for to
remove residual heat when the monobloc receiving OFF
command during heating operation.
2) If the heat pump malfunction occurs because of disturb,
please reconnect the heat pump to power, then turn on it again.
NOTE
Summary of Contents for DA-HP-16-230
Page 47: ......
