R
www.danvex.fi
1
4
Failure
Cause analysis
Method
Dehumidifier
cannot work
1.Power cut
2.Power switch is not
energized
3.Power cord is not
connected
4.Fuse is melted
1.Recover the power
2.Energize the power
3.Connect the power cord
4.Replace the fuse
Dehumidification is
not ideal
1.Dust accumulated in air
purification filter mesh
2.Object blocking air inlet
and outlet
3.The door or window is
open
4.Refrigerant is leaking
1.Clear the filter mesh
2.Remove
the
blocking
object
3.Close the door and
window
4.Contact with distributor or
manufacturer for repair
Water leak
1.The machine is inclined
2.Water pipe is blocked
1.Level the machine
2.Remove
the
blocking
object
Abnormal noise
1.The machine is not
placed solidly
2.The filter mesh is
blocked
1. Place the machine firmly.
2. Clear the filter mesh.
Common
Troubleshooting
1.Where the above troubles cannot be fixed and repair is needed, please contact
supplieror distributor. Do not disassemble without authorization.
2.When the dehumidifier is in operation or stops, voice of circulating of refrigerating can
be heard. Such phenomenon is normal.
3.It is normal for the air outlet to drain hot air.
Instruction
on
Code
of
Failure
This dehumidifier is able to automatically judge failure. If there is any failure, there will be
failure code displayed on the humidity display window.
Controller error codes
Failure Display Problem
E1
Temperature sensor failure
E2
Humidity sensor failure
E3
Phase sequence failure (for 380V power supply devices only)
E4
Water tank full (for the devices equipped water tank only)
E5
High temp./pressure
E6
Low pressure alarm (leakage may happen inside)