Dantherm DanX 1 XD, User Manual

Page: 6 / 60

2. TRANSPORTATION
4
2.1 Unloading
The unit is delivered in one module placed on wooden cross beams and wrapped in
protective packing. The following steps should be followed when unloading the modules:
•
Find a suitable place for unloading, as the unit can be heavy (up to 500 kg).
•
Unload the modules with a forklift or crane (see instructions below).
•
Do not tilt or lay down the unit with an integrated refrigeration system (DanX 1/2/3
HP).
•
Check packing and unit for damage in transit and report any damage to the driver and
to Dantherm Air Handling immediately.
•
Retain packing until the unit is placed on the mounting location to avoid damages on
cabinet parts or connecting pieces.
•
As the unit is delivered with a built in control panel, it should be handled with
caution and stored in a safe and dry location until installation is carried out.
2.2 Lifting with a forklift or crane
If a fork-lift is used, it must be ensured that the forks are long enough to fully reach under the
unit, so that the bottom of the cabinet is not damaged. Rough and incorrect handling can
damage the unit and hereby result in glitch.
Make sure that the unit’s centre of gravity is as
near as possible to the centre of the two forks, so the module can be transported stable.
When using a crane for lifting, please be aware of the following general points:
•
Only use a hoist that can manage the weight of the unit!
•
Never use a hoist which is damaged!
•
Use soft straps!
•
Lift the module cautiously, without jerky movements!
•
Do not touch down hard!
Never walk under a module when it is lifted with a crane. There is always a risk that the
crane or helping material may break and cause serious injury or death.
Lifting is carried out as follows:
•
Insert 2 bars of round iron (min. 1
”) in the holes of the base frame and secure them.
•
Use four soft straps, push them over the iron bars and put them together in the crane
hook.