30
Input & Output Interface
w w w . t e c n a r e . c o m
DAV-4x500 Amplifier | rev.:1.1
DAV-4x500
6. Input & Output Interface
The following plots show direct access from the input and output interface available within the M_
Console Software.
Fig. 45 Input & Output interface
6.1. Input Channel
The input channel interface from top to bottom includes:
Channel name,
Input mode, Channel gain, Function buttons, and Channel group joint debugging.
The Channel name, Input mode, and Channel group joint debugging can only be viewed, and there
is no editing function. In the Channel gain, you can see the level status of the input channel signal.
Among the function buttons, from top to bottom are: Mute
, Polarity , Noise gate ,
and Equalizer bypass . If the mute button is red, it is muted. If the
other but-
tons are green,
they are in effect.
Channel group, joint tuning shows the default 4 channel joint tuning group. When the background of
the corresponding number box turns yellow, it means that this channel has been added to the second group for joint
tuning.
The button bar in the middle of the input and output channels is the master switch of the function
button corresponding to all input and output channels. It will directly operate all input and output channels simulta-
neously.
6.2. Output Channel
The output channel interface from top to bottom includes: Channel name
, Channel gain,
Function buttons , and Channel group joint debugging .
Among them, the Channel name, Digital output status and Channel group joint debugging can only be viewed without
editing function. In the channel gain, you can see the level status of the output channel signal. The other two parts
(gain value box and gain slider) are for adjusting the gain value of this channel.
Among the function buttons, from top to bottom are: Mute , Equalizer bypass , Delay , Compressor
, Limiter , and Polarity . If the Mute button is red, it is muted. If the other buttons are green, they are in effect.
Summary of Contents for tecnare DAV-4x500
Page 2: ......
