13
Introduction
w w w . t e c n a r e . c o m
DAV-4x500 Amplifier | rev.:1.1
DAV-4x500
2.3. Front and Rear Panel
Fig. 1 Front and rear panel
The DVA4x500 DSP amplifier system is designed to be mounted in a standard 19”/1HU rack enclo
-
sure.
Where the amplifier is used in a fixed installation, it is possible to use only the front panel 19” rack
mounting holes to mount it in a standard rack enclosure. If the amplifier is mounted in a mobile rack it is recommend
-
ed that the rear rack mounting kit is fitted so the amplifier can be well supported. Damage caused by insufficient
support is not covered by the warranty.
To prevent damage to the front panel it is recommended that plastic cups or washers are fitted un
-
derneath the rack mounting bolt heads.
It is possible to mount multiple DVA4x500 amplifiers without ventilation gaps between them but it is
essential that an unobstructed flow of clean air is available from the back of the unit to the front. It is important the
neither the air intakes at the rear of the unit or the exhaust vents at the front are covered.
The amplifier should never be exposed to rain or moisture during operation or storage. If the unit
does come into contact with moisture, remove the AC power cord immediately and leave it in a dry and warm location
to dry out.
Note that when any equipment is taken from a cold location into a hot humid one, condensation may
occur inside the device. Always allow time for the equipment to attain the same temperature as its surrounding envi-
ronment before connecting the AC power cord.
Summary of Contents for tecnare DAV-4x500
Page 2: ......
