DN9231
User's Manual
01A.03
Dante Security Inc.
48
6.7. IO CONFIGURATION
6.7.1. DI/DO control
To set up DI/DO and UART, go to
Setup
>
IO Configuration > DI/DO
. In case of using additional
device such as alarm system or sensor system, you can configure the DI (Digital Input) and DO
(Digital Out) in this page.
DI Resource Type
You can choose the DI resource type, RELAY or VOLTAGE (The maximum is 5V).
DI & DO Status
It reflects the current states of actual DI and DO. 2 of DI and DO are supported on the device.
To understand DI/DO status options, refer to the following scenario.
Scenario
When it’s assumed that DI#1 and DO#1 are coupled by event system. The DI#1 trigger type is
Normal Open. Suddenly DI#1 is triggered by any kind of event.
Expected Response – The status of DO#1 will be changed from OFF to ON, if the default setting
is OFF. The status of DI#1 will be changed from OPEN to CLOSE.