DN9231
User's Manual
01A.03
Dante Security Inc.
46
If you are configuring DSP load, temperate, and video signal loss?
The option page provides the configuration of DSP load, temperature change, and video loss.
(1) Set the dspload limits to
E.g. Setting the value as 90% - While the DSP load keeps lower than 90%, the LED will operate
as you configured at Location tab.
(2) Set the temperature limits to
E.g. Setting the min 0 and max 65 - While the temperature is between 0 and 65, the LED will
operate as you configured at Location tab.
(3) Turn on the LED of Vsignal
Select one of the options between ‘When video signal loss is detected’ and ‘When video signal
is normal’. Then, the selected LED will operate when the selected condition is satisfied.
(4) Turn on the LED of Heartbeat
Select one of the options between ‘When heartbeat status is watchdog’ and ‘When heartbeat
status is normal’. Then, the selected LED will operate when the selected condition is satisfied.
6.6.7. DDNS (Dynamic DNS)
To change the Dynamic DNS setting, go to
Setup
>
System Options
>
DDNS
and follow the
procedures below.
1. Check the ‘Enable DDNS’ box.
2. Select the protocol type you want.
Note
i
DynDNS and Custom07 are installed on the device only.
3. Type the domain name you want to use for the product.
4. Type the update time. The factory default is 600 seconds and it enables the product notify
the DDNS of the current domain name.
5. Type the user name and password of your DDNS account. Note that 8 asterisks cannot be
used for the password.
6. Click the
Apply
button.