Dante DLA6332, Installation And Operation Manual

Page: 27 / 34

27
ID:0
Device name: qiuji
①
Device type: dome
Connection type: RS485
485 Add: 1 O_E VFY: None
PRTCL: DH-SD S-bit: 1
Baud: 9600
D-bit: 8
6666 Network
Network Network
Network KKKKeyboard
eyboard eyboard
eyboard C
C C
Control
ontrol ontrol
ontrol D
D D
Dome
ome ome
ome
6.1 6.1 6.1 6.1 Cable Cable Cable Cable C C C Connection onnection onnection onnection
Please make sure keyboard AB line and dome AB line connection is right.
Connect dome to power, and then connect dome video cable to the monitor.
Before operating, please go to dome menu to go on setup. If dome address is 1,
then keyboard RS 485 address is 1.
6.2
6.2 6.2
6.2 Keyboard
Keyboard Keyboard
Keyboard SSSSetup
etup etup
etup
In keyboard menu, go to control point.
Here you can input ID, device name.
You can use left/right key to select device type.
Use up/down to highlight connection type, then click ENTER to go to RS 485 setup.
485 address is 1, default protocol is DH-SD. You can select in accordance with you actual
demands.
After all the setup, click Enter to save setup or you can click ESC to exit without saving the
modification you have done.
6.3
6.3 6.3
6.3 Operation
Operation Operation
Operation
Before operation please note:
X value varies due to different protocols.
Please use up/down to move dome operation menu.
Use left/right to move cursor.
All the operation here is based on SD protocol. There may be some difference for various
protocols.
Now you can click ID key and input ID number to enter current device connection interface.
Current device
：
Dome
RS485 ADD
：
1
ID
：
0