Danmeter CSM 2, User Manual

Page: 34 / 39

Cerebral State Monitor - CSM DFU Page 30
15 Technical description
Guidance and manufacturer’s declaration — electromagnetic emissions
The Cerebral State Monitor CSM is intended for use in the electromagnetic environment specified below. The
customer or the user of the CSM should assure that it is used in such an environment.
Emissions test
Compliance Electromagnetic environment —
guidance
RF emission
CISPR 11 Group 1 The Cerebral State Monitor CSM uses
RF energy only for its internal function.
Therefore, its RF emissions are very
low and are not likely to cause any
interference in nearby electronic
equipment.
RF emission
CISPR 11 Class B
Harmonic emission
IEC / EN 61000-3-2 Not Applicable
Voltage fluctuations/
flicker emissions
IEC / EN 61000-3-3 Not Applicable
The Cerebral State Monitor CSM is
suitable for use in all establishments,
including domestic establishments and
those directly connected to the public
low-voltage power supply network that
supplies buildings used for domestic
purposes.
Guidance and manufacturer’s declaration — electromagnetic immunity
The CSM is intended for use in the electromagnetic environment specified below. The customer or the user
of the CSM should assure that it is used in such an environment,
Immunity test
IEC / EN 60601
test level Compliance level Electromagnetic
environment –
guidance
Electrostatic
discharge (ESD)
IEC / EN 61000-4-2 ±6 kV contact
±8 kV air ±6 kV contact
±8 kV air Floors should be
wood, concrete or
ceramic tile. If floors
are covered with
synthetic material, the
relative humidity
should be at least
30%.
Electrical fast
transient/burst
IEC / EN 61000-4-4 ±2 kV for power
supply lines
±1 kV for
input/output lines Not Applicable Mains power quality
should be that of a
typical commercial or
hospital environment.
Surge
IEC / EN 61000-4-5 ±1 kV differential
mode Not Applicable Mains power quality
should be that of a
t i l i l