461308061 (001) 05/2012
16
INSTRUCTION FOR THE INSTALLER
MAINTENANCE
Before replacing any spare parts it is vital to
disconnect the appliance from the electricity
mains.
REPLACNG THE THERMOSTAT (fig. 12)
To change the thermostat proceed as follows:
• Take the oven out of its housing by unscrewing the
screws (V) (fig. 12).
• Pull the knobs off.
• Remove the front panel by unscrewing the screws
(V) (fig. 13).
• Disassemble the protection box (S) (fig. 14).
12
�
13
REPLACING ELECTRICAL COMPONENTS
• To replace the oven lamp please refer to instructions
on page 10.
• To access the other electrical components you will
have to take the oven out of its housing by unscrewing
the screws (V) (fig. 13).
By simply pulling the oven out you will be able to work
directly on the terminal board and on the power cable
(fig. 14)
•
If the power cable needs changing, connect a
cable with a suitable cross section (see the table
on page 12) keeping the earth wire longer than the
phase wires. In addition, follow the instructions
giving in the “ELECTRICAL CONNECTION”
paragraph.
•
To change the lamp holder fig.6
, remove the
superior protection (A) and the side panel, then use a
screwdriver to push the two locking tabs (fig. 15) and
remove the lamp holder from the inside of the oven.
• To replace other electrical components (igniter,
temperature limiting device, tangential fan, gear
motor, warning light, electronic clock and switch) you
will have to take the rear guard off (Q) and the box (S)
as well as the protective shell (A) (fig. 14).
• To take the control panel off, remove the knobs and
unscrew the screws (V) (fig. 13).
�
�
�
�
14
�
�
�
15
• Unscrew the check nuts (D) from the supply rails
and safety thermocouples.
• Unscrew screw (V) to free the thermostat (T).
• Change the seal (G) each time you change the
thermostat. This is to guarantee a perfect seal
between thermostat and rail.
