Danfoss VLT, Pocket Manual, Page: 53 / 64

VLT ® Soft Starter Pocket Guide 53
This requires an MCD DeviceNet Module which clips onto the side of
the MCD200 (Cat. No: 175G9002).
Notes
A single DeviceNet Module is required for each MCD200. •
DeviceNet node address (MAC ID) and data rate are selected using •
three rotary switches on the DeviceNet Module.
Up to 63 DeviceNet Modules can be used as DeviceNet slaves
•
on a single DeviceNet network.
The DeviceNet Module is powered via the network cable.
•
The MCD DeviceNet Module is ODVA tested and certifi ed. •
For more information on the MCD DeviceNet Module, refer to the •
Installation Instructions (MG.17.Hx.02), located at
www.danfoss.com/drives.
MCD200
MCD
DeviceNet
Module
RD
(V+)
WH
(CAN-H)
BK
(V-)
BU
(CAN-L)
(SHIELD)
Standard 5-wire
connection onto a
DeviceNet network.
120 termination
resistors are required
at end of each end
of the network cable.
Cat. No: 175G9002
MCD200 DeviceNet Option