![background image](http://html1.mh-extra.com/html/danfoss/vlt-safety-option-mcb-150/vlt-safety-option-mcb-150_operating-instructions-manual_3452158008.webp)
130BC961.11
+
MCT 10 + Safe Plug- in
Commissioning Report
Install
Use Manual for FC
Use Manual for MCB 150/151
Parameterize
Use Manual for
MCT 10 Safe
Plug-in
Test
Use Commissioning
Report generated via
MCT 10 Safe Plug-in
Report
Rev.Sequence: A, 3
MCT 10
Commisioning report
3 February 2012
Property of Danfoss A/S. Not to be handed over to, copied, or used by third party. Two - or three - dimensional
reproduction of contents to be authorized by Danfoss A/S.
302
FC 302
MCB 15x
Illustration 1.1 System Overview
Referenced literature
•
VLT
®
AutomationDrive FC 301/FC 302 Operating
Instructions
•
MCT 10 Set-up Software Operating Instruction
Also refer to
for additional
information.
1.3 Abbreviations and Definitions
Blank Initial
State
Factory settings
Cat.
Category (EN ISO 13849-1)
CCF
Common Cause Failure (IEC 61508, IEC 62061, EN
61511-1, EN ISO 13849-1)
CCW
Counter Clockwise
CW
Clockwise
DC
Diagnostic Coverage (EN ISO 13849-1, IEC
62061(IEC 61508-2))
Degree of
protection
The degree of protection is a standardized
specification for electrical equipment that
describes the protection against the ingress of
foreign objects and water (for example: IP20).
DIx
DI1: Digital Input 1
DI2: Digital Input 2
EMC
Electromagnetic compatibility
Encoder
Sensor for detection of the angular position of a
rotating component. Installed on/in a motor, the
encoder shows the angular position of the rotor.
Error
Discrepancy between a computed, observed or
measured value or condition and the specified or
theoretically correct value or condition.
Error class
Classification of errors into groups. The different
error classes allow for specific responses to
errors, for example by severity.
Factory
setting
Factory settings when the product is shipped
Fatal error
In the case of fatal error, the product is no
longer able to control the motor so that the
power stage must be immediately disabled.
Fault
Fault is a state that can be caused by an error
Fault reset
A function used to restore the frequency
converter to an operational state after a detected
error is cleared by removing the cause of the
error so that the error is no longer active.
MTTF/MTTFd
Mean time to failure/Mean time to dangerous
failure (EN ISO 13849-1)
OSSD
Output Signal Switching Device (EN 61496-1)
Parameter
Device data and values that can be read and set
(to a certain extent) by the user
PDS(SR)
Power Drive System (Safety Related)
PELV
Protective Extra Low Voltage, low voltage with
isolation. For more information: IEC 60364-4-41
or IEC 60204-1.
PFD
Probability of Failure on Demand (IEC 61508, IEC
62061)
PFH
Probability of Failure per Hour (IEC 62061 and
IEC61508)
PLC
Programmable logic controller
Introduction
Operating Instructions
6
Danfoss A/S © Rev. 2014-02-11 All rights reserved.
MG34W302
1
1
Summary of Contents for VLT Safety Option MCB 150
Page 2: ......