6.3 LCP Menu
6.3.1.1 Quick Menu Mode
The Quick Menus mode provides a list of menus used to
configure and operate the drive. Select the Quick Menus
mode by pressing the [Quick Menus] key. The resulting
readout appears on the LCP display.
130BF241.10
01 My Personal Menu
02 Quick Setup
05 Changes Made
06 Loggings
0.0% 0.00
Quick Menus
1(1)
03 Function Setups
04 Smart Start
Illustration 6.1 Quick Menu View
6.3.1.2 Q1 My Personal Menu
The Personal Menu is used to determine what is shown in
the display area. Refer to
chapter 3.6 Local Control Panel
. This menu can also show up to 50 pre-programmed
parameters. These 50 parameters are manually entered
using
parameter 0-25 My Personal Menu
.
6.3.1.3 Q2 Quick Setup
The parameters found in the
Q2 Quick Setup
contain basic
system and motor data that are always necessary for
configuring the drive. See
for the set-up procedures.
6.3.1.4 Q3 Function Setups
The parameters found in the
Q3 Function Setups
contain
data for fan, compressor, and pump functions. This menu
also includes parameters for LCP display, digital preset
speeds, scaling of analog references, closed-loop single
zone, and multizone applications.
6.3.1.5 Q4 Smart Start
Q4 Smart Setup guides the user through typical parameter
settings used to configure the motor and selected
pump/fan application. The [Info] key can be used to
display help information for various selections, settings,
and messages.
6.3.1.6 Q5 Changes Made
Select
Q5 Changes Made
for information about:
•
The 10 most recent changes.
•
Changes made from default setting.
6.3.1.7 Q6 Loggings
Use
Q6 Loggings
for fault finding. To get information about
the display line readout, select
Loggings
. The information is
shown as graphs. Only parameters selected in
parameter 0-20 Display Line 1.1 Small
through
parameter 0-24 Display Line 3 Large
can be viewed. It is
possible to store up to 120 samples in the memory for
later reference.
Q6 Loggings
Parameter 0-20 Display Line 1.1 Small
Reference [%]
Parameter 0-21 Display Line 1.2 Small
Motor current [A]
Parameter 0-22 Display Line 1.3 Small
Power [kW]
Parameter 0-23 Display Line 2 Large
Frequency [Hz]
Parameter 0-24 Display Line 3 Large
kWh Counter
Table 6.1 Logging Parameter Examples
6.3.1.8 Main Menu Mode
The
Main Menu
mode lists all the parameter groups
available to the drive. Select the Main Menu mode by
pressing the [Main Menu] key. The resulting readout
appears on the LCP display.
e30bg272.10
O-** Operation / Display
1-** Load and Motor
2-** Brakes
3-** Reference / Ramps
0 RPM 0.00 A
Main Menu
1(1)
Illustration 6.2 Main Menu View
All parameters can be changed in the main menu. Option
cards added to the unit enable extra parameters associated
with the option device.
Commissioning
VLT® Refrigeration Drive FC 103
50
Danfoss A/S © 04/2018 All rights reserved.
MG16P222
6
6