Danfoss VLT AutomationDrive FC 360, Application Manual

Page: 3 / 31

1 Introduction
1.1 Purpose of the Manual
This manual provides information on how to design and
implement center winder control and positioning control
applications with FC 360 frequency converters. It does not
cover general design, installation and commissioning of
the frequency converter.
VLT
®
is a registered trademark.
Prerequisites
The manual is intended for use by qualified personnel who
are familiar with the functions of VLT
®
AutomationDrive FC
360 and have hands-on experience with installing and
commissioning FC 360 frequency converters. The
frequency converter should be installed and commissioned
according to the FC 360 Quick Guide. Users of this manual
should have the Quick Guide at hand for reference.
1.2 Additional Resources
Additional resources are available to understand frequency
converter functions and programming.
•
VLT
®
AutomationDrive FC 360 Quick Guide ,
provides information required to install and
commission the frequency converter.
•
VLT
®
AutomationDrive FC 360 Design Guide ,
provides detailed information about the design
and applications of the frequency converter.
•
VLT
®
AutomationDrive FC 360 Programming Guide ,
provides information on how to programme and
includes complete parameter descriptions.
Contact the local Danfoss supplier for the printed
documentation.
1.3 Document and Software Version
This manual is regularly reviewed and updated. All
suggestions for improvement are welcome.
Table 1.1 shows
the document version and the corresponding software
version.
In the frequency converter, read the software version in
15-43 Software Version .
Version Remarks Software version
MG06E1 First version of the document. 1.4x
Table 1.1 Document and Software Version
1.4 Abbreviations and Conventions
AC Alternating current
AEO Automatic energy optimisation
ACP Application control processor
AWG American wire gauge
AMA Automatic motor adaptation
°
C Degrees Celsius
DC Direct current
EEPROM
Electrically erasable programmable
read-only memory
EMC Electromagnetic compatibility
EMI Electromagnetic interference
ETR Electronic thermal relay
f
M,N
Nominal motor frequency
FC Frequency converter
IP Ingress protection
I
LIM
Current limit
I
INV
Rated inverter output current
I
M,N
Nominal motor current
I
VLT,MAX
Maximum output current
I
VLT,N
Rated output current supplied by the
frequency converter
L
d
d-axis inductance
LCP Local control panel
MCP Motor control processor
N.A. Not applicable
P
M,N
Nominal motor power
PCB Printed circuit board
PE Protective earth
PELV Protective extra low voltage
PWM Pulse width modulated
R
s
Stator resistance
Regen Regenerative terminals
RPM Revolutions per minute
RFI Radio frequency interference
SCR Silicon controlled rectifier
SMPS Switch mode power supply
T
LIM
Torque limit
U
M,N
Nominal motor voltage
X
h
Main reactance
Table 1.2 Abbreviations
Conventions
•
Numbered lists indicate procedures.
•
Bullet lists indicate other information.
•
Italicised text indicates
Introduction
VLT
®
AutomationDrive FC 360
2 Danfoss A/S © 11/2014 All rights reserved. MG06E102
1 1