Install the two mounting brackets on the drive
chassis and then install the bottom duct adapter
on the bottom of the drive as shown in Photo 5.
The installation of the bottom plate is easier while
the back panel is outside the enclosure. The
curved leading edge of the bottom duct adapter is
to the front of the drive and down. IMPORTANT:
Install the bottom plate after the drive has been
installed on the back panel to assure proper gas-
ket coverage.
Photo 5. Bottom duct adapter in-
stalled
Attached to chassis brackets
Photo 7. Drive installed
in cabinet—D4 Frame
Before installing the back panel with the drive in
the enclosure, remove and discard the rear-most
screws (Photo 6) that are located on the top cover
of the drive. The holes will be used to fasten the
top ductwork with longer screws provided with the
kit.
Install the backpanel in the enclosure (Photo 7).
Use Rittal PS4593.000 brackets (minimum one
per side at the middle of the drive) with
appropriate support strip for additional support
of the backpanel. For the D4 frame use two
supports per side. Consult the Rittal manual for
additional support requirements if additional
components are mounted on the same back
panel.
Photo 6. Top of IP00/Chassis drive
Instruction No: 175R5640 V3
Aug 13, 2008
Page 4
