6
Systems with dial thermostats
continued
Operating instructions for the underfloor heating timeclocks
TS715 – Single-channel timeclock
Nu-Heat supplies Danfoss TS715 single-channel programmable floor heating
timeclocks to control the underfloor heating system.
Room zone temperatures are individually controlled by simple dial-type thermostats.
Please remember that underfloor heating takes longer to warm up and cool down
than conventional radiators and the timeclock settings should reflect this.
Ensure that each timeclock is set to your requirements as follows:-
Programming – day and time
1.
Open the cover. Press
prog
to enter
programming mode.
2.
Press
day
to select day of the week.
Repeat until correct day is displayed.
3.
Use
+
or
-
to adjust the time until
correct.
SELECT
PROG
NEXT ON/OFF
+
–
DAY
COPY
R/S
12:00
PM
MO
ON
OFF
AUTO
ALL DAY
+1HR
MAN
SELECT
PROG
NEXT ON/OFF
+
–
DAY
COPY
R/S
12:00
PM
TU
SET
TIME
+1HR
MAN
SELECT
PROG
NEXT ON/OFF
+
–
DAY
COPY
R/S
12:02
PM
MO
SET
TIME
+1HR
MAN
SELECT
PROG
NEXT ON/OFF
+
–
DAY
COPY
R/S
12:00
PM
MO
SET
TIME
+1HR
MAN
SELECT
PROG
NEXT ON/OFF
+
–
DAY
COPY
R/S
4:30
AM
MO
SET
TIME
1
ON
+1HR
MAN
SELECT
PROG
NEXT ON/OFF
+
–
DAY
COPY
R/S
8:00
AM
MO
SET
TIME
2
OFF
+1HR
MAN
SELECT
PROG
NEXT ON/OFF
+
–
DAY
COPY
R/S
11:15
MO
SET
TIME
6
OFF
PM
+1HR
MAN
SELECT
PROG
NEXT ON/OFF
+
–
DAY
COPY
R/S
12:30
PM
TU
SET
TIME
4
OFF
+1HR
MAN
SELECT
PROG
NEXT ON/OFF
+
–
DAY
COPY
R/S
11:15
PM
FR
SET
TIME
6
OFF
+1HR
MAN
Programming –
on/off
times
4.
Press
prog
to enter
on/off
programming mode.
5.
Use
+
or
-
to adjust the 1st
on
time,
(setting number 1).
6.
Press
next
to step to 1st
off
time,
(setting number 2).
7.
Use
+
or
-
to adjust the 1st
off
time,
(setting number 2).
8.
Press
next
and repeat steps 5 – 7
until all
on/off
times are
programmed to suit.
9.
If unit is pre-set for 24 hour operation
go to step 13, If a different cycle is
required, alter the internal pins and
continue with step 10 (see opposite).
10.
Press
day
to advance to the next day
if different programming from the
previous day is required.
If the programme is the same, go
to step 11.
11.
Press the
copy
button to copy the
previous day’s programming to the
current day.
12.
Repeat steps 10 – 11 until all days
are programmed.
13.
Press
prog
to return to
run
mode.
