2
PART NUMBER CONFIGURATION
Hardware Configuration Table.
Road Sentry Console
Revision Letter
Control Application
(1)
Asphalt paver
(2)
Planer, reclaimer
Controller Outputs
(5)
Solenoid or servovalve, high side switch
(6)
Solenoid, low side switch
Display Configuration
(1)
One setting/message display, non-backlit switches
(2)
Two setting/message displays, non-backlit switches
(3)
One setting/message display, backlit switches
(4)
Two setting/message displays, backlit switches
Special Configuration
00 and as required
Mounting Configuration
(5)
Bottom flange mount
(6)
1/2-13 side studs *
* Consult factory for availability
K G S A X X
To assist in configuring the hardware for the Road Sentry Console, determine the correct part number from the table below.
Contact Danfoss for assistance in specifying the required software.
Control Application
1. Asphalt paver control software is compatible with a 10
inch grade wand. Machine travel is 4 inches above and
1 inch below the setup reference zero. When resetting
auto mode (from manual mode) the prior setpoint is
saved and resumed. The machine will automatically
return to the previous setpoint.
2. Planer, reclaimer control software is compatible with a
25 inch grade wand. Machine travel is 10 inches below
and 2.5 inches above the setup reference zero. Actuating
the up/down toggle switch places the control in manual.
When resetting auto mode (from manual mode) the prior
setpoint is not saved but must be reset by the operator.
The motion interlocks are disabled with this option.
Controller Outputs
5. Solenoid valve or servovalve, high side switched. The
controller output is designed to drive servovalves, on/off
or proportional solenoid valves with the two valve coils
permanently grounded.
6. Solenoid valve, low side switched. The controller output
is designed to drive on/off or proportional solenoid
valves with the two valve coils permanently tied to
battery “+”.
Display Configuration
1. One setting/message display. The eight character
alphanumeric display is used for both setpoint position
and actual position. The setpoint/actual switch controls
which value is displayed. Switches are not backlit.
2. Two setting/message displays. The faceplate has one
eight character display for setpoint position and one for
actual position. There is no setpoint/actual switch.
Switches are not backlit.
3. One setting/message display, backlit switches. The
backlit switch configuration features illumination behind
each push switch that makes them night-readable. A
photo sensor turns the backlight on and off.
4. Two setting/message displays, backlit switches. The
backlit switch configuration features illumination behind
each push switch that makes them night-readable. A
photo sensor turns the backlight on and off.
Mounting Configuration
5. Bottom flange mount. This requires a flat surface with
two holes for 5/16 inch diameter fasteners.
6. 1/2-13 side studs. This requires a yoke with slots for the
studs.