© Danfoss | Climate solutions | 2023.09
4 | AN461947453648en-000101
Power on & start operation
ICAD has a light guide viewable from three sides, which indicates the status. Immediately after power on the light guide and display
lights up.
Data communication
Power supply
Control signals
The main screen layout and navigation is as described below. ICAD will start up in alarm mode as the ICM configuration needs to be
defined to start operation. Follow the steps on next page to set this up correctly.
ICAD name
Status
Actual opening degree
STATUS BAR
STATUS BAR
Alarm | Warning | Service overdue | Modbus address | Bluetooth ON | UPS enabled
Back one level
On main screen show alarms
ARROW UP
Navigate up
Show I/O status
ARROW DOWN
Navigate down
Show I/O status
ENTER
Open menu / Down one level
Set parameter on lowest level
EXIT
ENGLISH
Light guide
Steady red
Critical alarm - stopped operating
Flashing red
Severe alarm - danger of stopping operating
Flashing blue
ICAD is connected via Bluetooth
Flashing yellow
Warning
Flashing green
OK