4
Danfoss
FT1390 Crimp Machine Operator´s Manual October 2022
Specifications
Specifications
Electrical requirements
FT1390-115
110 to 120-Volt AC single phase 60 Hz
circuit with a minimum of 25 amps
FT1390-230
208 to 230-Volt AC single phase 50/60 Hz
circuit with a minimum of 15 amps
Crimp machine dimensions
Width
29 inches
Depth
28 inches
Height
45 inches
Weight
825 pounds
Production capacity
Danfoss braided and spiral hydraulic hoses up to 2" (-32).
1 & 2-wire Hydraulic Hose
sizes thru -32
Thermoplastic Hose
sizes thru -32
(Where
Applicable)
100R5 hose
sizes thru -32
4 & 6-wire
sizes thru -32
Hydraulic Hose
OTC Flat or OTC Beer Can Crimp
Note:
Some hoses may require a positive back-stop.
Check the PowerSource Crimp Spec tool for Crimp Specs
prior to crimping.
Setup and installation
Machine capability
1. Mount your Danfoss FT1390 crimp machine to
the floor using the holes provided in the corners of the crimp
machine base.
2. Remove the plug from the hydraulic reservoir vent port and
replace it with the vent cap that is supplied with the unit.
Caution:
Failure to do so will cause cavitation and damage to
the pumping mechanism. Hand tighten the vent cap.
3. Caution:
Provide electrical service with a dedicated circuit
(per the crimp machine electrical requirements) in order to
eliminate the possibility of a low-voltage situation.
4. Never use an extension cord. Always plug the unit directly into
the power outlet.
Caution:
Summary of Contents for FT1390
Page 1: ...Crimp machine operator s manual Danfoss FT1390 crimp machine...
Page 19: ......
