Danfoss ET5070, Operator'S Manual, Page: 41 / 96

WARNING!
Risk of squeezing!
When the die system closes, there is a risk of getting squeezed
between the die and the workpiece.
• Keep the feed opening for the workpiece as small as possi-
ble.
• Keep a minimum distance of 120 mm (A) to the die system.
1. Manually position the pre-mounted workpiece in the tool.
2. Hold the workpiece with one hand during the forming process.
3. Press and hold the button [ ] to close the tool; the forming pro-
cess starts and ends when the pre-set diameter/pressure is
reached.
4. Manual operation mode: Press the [ ] button upon comple-
tion of the forming process to open the tool.
5. Semiautomatical operation mode: Wait until the hold time de-
fined in the control has expired; the tool will then open automati-
cally.
6. Remove the workpiece from the tool.
7. Check the forming dimension after the first forming process.
Correct the forming dimension in case of deviations between the
actual dimension an
d the specified dimension (see “Setting the
forming dimension
” in Section 5).
Open the crimping tool only so much that the hose may be placed
and/or removed easily. Excessive opening means risk of squee-
zing and time loss.