Danfoss ET5070, Operator'S Manual, Page: 28 / 96

activates the depth stop by pressure. Press the button
to open the tool.
As soon as the pre-set forming diameter or forming pressure is
reached in the control, the tool stops and opens automatically.
•
Semi-automatic operation
C.2 / IPC is activated in the control. The forming process
is started manually via the buttons on the control panel or exter-
nal buttons, e.g. the dual foot switch:
–
Activate the button for closing and forming.
–
Dual foot switch
The right foot switch is used for closing.
–
Depth stop
The tool is closed automatically when the workpiece acti-
vates the depth stop by pressure.
As soon as the forming diameter or forming pressure as defined
in the control is reached, the tool stops and opens automatically
after the preset holding time.
Production is possible in any operation mode.
The operation mode selected before deactivating the machine will
be active upon a restart. The operation modes are set on the con-
trol panel.
When the Foot switch button [ ] is activated, the Close tool but-
ton [ ] is inoperative, even if the button is illuminated. The Open
tool button is always active independently.
The operation of the control system is described in a separate Op-
eration Manual. This description is supplied with the machine.